![]() ![]() and vfat: kmod-fs-vfat, please, could you compile and share it with me block info If you did find it useful give it a thumps !!! im close, but i need to mount now the filesystem and i need to install addons, ext. If you didn't keep a backup in the beginning ask someone to send you the partition you need. If you did overwrite some other partition by mistyping DON'T REBOOTĮspecially if is the mtd0 (is the u-boot partition your router will not boot if you overwrite it) They should match else write again the partition in the step 5 ![]() Scp mtd3 the partition (you will need to install kmod-mtd-rw) (change the ip here if needed, don't forget the dot in the end, is a part of the command)Ĭ) open with a hex editor and find your mac (you should have only one result otherwise something is wrong)ĭ) edit with your desired mac and save it You can skip mtd9 you can recover with out it in case something is go wrong)Įdit it on the computer with a hex editor (this step probably can be done here as well, i didn't spend the time to find how)Ī) transfer the file ( i chose scp for this step) (is a good idea to keep a backup from all the partitions so repeat this command changing the mtd3 with mtd0 mtd1. You should have the same partition table else don't continue Ok, the setting that you will need to change is located in the mtd3 partition Wrong actions can hard brick your device. ** Disclaimer: be careful, openwrt by default have lock the partition writing and we going to undo this. Since i didn't find anywhere else how to do it im sharing the way i used to solve this problem. ![]() Only by writing on the eeprom i find that is possible to fix this. Changing the mac with uci dosen't allow clients to connect. Tutorial: How to change the mac on the eeprom. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |